Indicator Blink Rates - Oracle X5-8 Service Manual

Troubleshoot Hardware Faults
For indicator blink rate information, see
Front Panel Lamp Test
To perform a lamp test of all front panel indicators, press the Locate button three times within
a five second period. All the front and back indicators light up and remain on steady for 15
seconds (see
For indicator blink rate information, see

Indicator Blink Rates

This section describes the following indicator blink rates:
"Steady On" on page 62
■
"Steady Off" on page 63
■
"Slow Blink Rate" on page 63
■
"Fast Blink Rate" on page 64
■
"Single (Standby) Blink Rate" on page 64
■
"Slow Unison Blink Rate" on page 65
■
"Insertion Blink" on page 65
■
"Unison Steady On" on page 66
■
"Alternating (Invalid FRU) Blink Rate" on page 66
■
"Feedback Flash" on page 67
■
"Data Blink Rate" on page 67
■
"Sequential (Diagnostic) Blink Rate" on page 67
■
Steady On
For the steady on state, an indicator is continually on (lit) and does not blink. This indicates a
continuing condition, for example, an operational state (green) or a Service Action Required
fault state (amber).
62 Oracle Server X5-8 Service Manual • December 2015
"Unison Steady On" on page
"Indicator Blink Rates" on page
66).
"Indicator Blink Rates" on page
62.
62.