Oracle X5-8 Service Manual page 106

Remove Power
power cables from the back of the server. Use this procedure to completely remove power from
the server.
See: "Power Modes, Shutdowns, and Resets" on page 107
Before You Begin
1. Place the server in standby power mode.
Use one of the power off methods. See
Access the back of the server.
2.
3. To remove power from the server, lift the power cord retaining clips, and
disconnect each AC power cable from the AC power block.
This action completely removes power from the server.
4. If you are performing a cold reset, wait at least 60 seconds before connecting the
AC power cables to the power supplies.
For information about cold resets, see
106 Oracle Server X5-8 Service Manual • December 2015
"Powering Off the Server" on page
"Cold Reset" on page 108.
100.