Install A Cmod - Oracle X5-8 Service Manual

2. To install the cover, position it over the CMOD chassis with the green button at
the front.
3. Set the cover on the chassis, leaving a gap of approximately one inch (25 mm)
between the lead edge of the cover and the front of the CMOD.
4. Ensure that the edges of the cover encapsulate the edges of the chassis, and
that the pins in the cover are aligned with the slots in the chassis sidewall.
5. Slide the cover toward the front of the CMOD until it locks into place.
This action is accompanied by a click sound.

Install a CMOD

Use this procedure to install a CMOD after replacing it or after servicing its internal
components.
"Remove a CMOD" on page
Before You Begin ■
For component serviceability, locations, and designations, see
■
Designations" on page
137.
79.
Install a CMOD
"Component Locations, and
Servicing Components 143