Rocker Arm Assemblv Installation - Honda Civic Service Manual

Cylinder Head
Rocker Arm Assembly Installation
:,ean and dry the No. 5 rocker shaft holder mating
surfaces.
eeassemble the rocker arm assembly (see page 6-
2 1 t .
Apply liquid gasket, P/N 08718-0009, evenly to the
:ylinder head mating surface ofthe No. 5 rocker
shaft holder.
\OTE: Do not lnstall the parts if 5 minutes or more
r a v e e l a p s e d s i n c e a p p l y i n g l i q u i d g a s k e t . I n s t e a d ,
'eapply liquid gasket after removing old residue.
Insert the bolts (A) into the rocker shaft holder, then
install the rocker arm assembly (B) on the cylinder
h e a d .
Apply liquid gasket
along the broken line.
6-38
l-
\
5 .
6 .
Remove the bolts from the rocker shaft holder.
M a k e s u r e t h e D U n c h m a r k s o n t h e v a r i a b l e v a l v e
timing control (VTC) actuator and exhaust camshaft
sprocket are facing up. then set the camshafts (A) in
the holder.
Set the camshaft holders (B) and cam chain guide B
( C ) i n p l a c e .
Tighten the bolts to the specified torque.
Specified torque:
8 mm bolts:
22 N.m (2.2 kgf.m, 16 lbl.ft)
6 mm bolts:
12 N.m {1.2 kgf.m,8.7 lbf.fil
6 mm bolts: @),@.@
lnstall the cam chain (see page 6-15). and adjust the
valve clearance (see page 6-9).
I
fl
c
a
\-
7 .
{