Configuring Remote Bridging - Huawei AR530 series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Ethernet Switching
l
----End

9.6.3 Configuring Remote Bridging

Configuring remote bridging allows users in different geographical locations and on the same
network segment to communicate with each other.
9.6.3.1 Creating a Bridge Group
Context
A bridge group is a virtual group. It can forward packets only after interfaces have been added
to the group.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
A bridge group is created and the bridge group view is displayed.
If the bridge group specified by bridge-id exists, the bridge group view is displayed.
Multiple devices can use the same bridge number.
----End
9.6.3.2 Adding a LAN-side Interface to a Bridge Group
Context
A bridge group is a virtual group. It can forward packets only after interfaces have been added
to the group.
As shown in
l
l
l
Issue 01 (2014-11-30)
Run the display bridge traffic [ bridge bridge-id | interface interface-type interface-
number ] command to view the traffic statistics on a specified interface in the bridge group.
Figure 9-16, the following methods can be used to add users to a bridge group:
Directly add users to the bridge group. User 1 uses this method.
Use a VLAN to add users to the bridge group. Create a VLAN on a bridge and add users
to the VLAN. Users then connect to the bridge group through the VLANIF interface. User
2 and User 3 use this method.
Use Ethernet sub-interfaces to add users to the bridge group. This method is used when
flows on a physical interface need to be differentiated using sub-interfaces. User 4 uses this
method.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Transparent Bridging Configuration
368