Optional) Configuring The Range Of Groups An Interface Can Join - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
members and keeps on forwarding matched multicast packets to the network segment where this
interface resides.
Context
Do as follows on the switch connected to hosts:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
mld static-group ipv6-group-address [ inc-step-mask ipv6-group-mask-length number
group-number ] [ source ipv6-source-address ]
The interface is configured to statically join a single multicast group or multiple multicast groups
in batches. After the interface statically joins the multicast groups, the switch considers that the
members of the multicast groups exist on the network segment where the interface resides.
----End
10.3.6 (Optional) Configuring the Range of Groups an Interface Can
Join
You can configure the range of groups on the interface of a multicast device connected with the
user network segment so that user hosts can join only a specified range of multicast groups.
Context
Do as follows on the switch connected to hosts:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
Issue 01 (2011-07-15)
NOTE
This configuration is optional. By default, the interface does not statically join any group.
NOTE
This configuration is optional. By default, the interface can join any group.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 MLD Configuration
361