Displaying Connection Status - Edge-Core ECS3510-26P Management Manual

D
ISPLAYING
C S
ONNECTION TATUS
Figure 26: Configuring Connections by Port Range
Use the Interface > Port > General (Show Information) page to display the
current connection status, including link state, speed/duplex mode, flow
control, and auto-negotiation.
CLI R
EFERENCES
"show interfaces status" on page 741
◆
P
ARAMETERS
These parameters are displayed:
Port – Port identifier.
◆
Type – Indicates the port type. (100Base-TX, 100Base-FX,
◆
1000Base-T, 1000Base SFP)
Name – Interface label.
◆
Admin – Shows if the port is enabled or disabled.
◆
Oper Status – Indicates if the link is Up or Down.
◆
◆ Media Type – Not applicable for this switch.
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
◆
Oper Speed Duplex – Shows the current speed and duplex mode.
◆
Oper Flow Control – Shows the flow control type used.
◆
– 131 –
| Interface Configuration
C 5
HAPTER
Port Configuration