Configuring Static Dns Host To Address Entries - Edge-Core ECS3510-26P Management Manual

C S
ONFIGURING TATIC
To show the list name servers:
Click IP Service, DNS, General.
1.
Select Show Name Servers from the Action list.
2.
Figure 278: Showing the List of Name Servers for DNS
DNS H A
OST TO DDRESS
Use the IP Service > DNS - Static Host Table (Add) page to manually
configure static entries in the DNS table that are used to map domain
names to IP addresses.
CLI R
EFERENCES
"ip host" on page 948
◆
"show hosts" on page 952
◆
C U
OMMAND SAGE
Static entries may be used for local devices connected directly to the
◆
attached network, or for commonly used resources located elsewhere
on the network.
P
ARAMETERS
These parameters are displayed:
Host Name – Name of a host device that is mapped to one or more IP
◆
addresses. (Range: 1-127 characters)
IP Address – IPv4 or IPv6 address(es) associated with a host name.
◆
W I
EB NTERFACE
To configure static entries in the DNS table:
Click IP Service, DNS, Static Host Table.
1.
Select Add from the Action list.
2.
Enter a host name and the corresponding address.
3.
– 467 –
C
HAPTER

Configuring Static DNS Host to Address Entries

E
NTRIES
| IP Services
16