Edge-Core ECS3510-26P Management Manual page 209

RSTP: Rapid Spanning Tree (IEEE 802.1w); RSTP is the default.
■
MSTP: Multiple Spanning Tree (IEEE 802.1s)
■
Priority – Bridge priority is used in selecting the root device, root port,
◆
and designated port. The device with the highest priority becomes the
STA root device. However, if all devices have the same priority, the
device with the lowest MAC address will then become the root device.
(Note that lower numeric values indicate higher priority.)
Default: 32768
■
Range: 0-61440, in steps of 4096
■
Options: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672,
■
32768, 36864, 40960, 45056, 49152, 53248, 57344, 61440
Advanced Configuration Settings
The following attributes are based on RSTP, but also apply to STP since the
switch uses a backwards-compatible subset of RSTP to implement STP, and
also apply to MSTP which is based on RSTP according to the standard:
Path Cost Method – The path cost is used to determine the best path
◆
between devices. The path cost method is used to determine the range
of values that can be assigned to each interface.
Long: Specifies 32-bit based values that range from 1-200,000,000.
■
(This is the default.)
Short: Specifies 16-bit based values that range from 1-65535.
■
Transmission Limit – The maximum transmission rate for BPDUs is
◆
specified by setting the minimum interval between the transmission of
consecutive protocol messages. (Range: 1-10; Default: 3)
When the Switch Becomes Root
Hello Time – Interval (in seconds) at which the root device transmits a
◆
configuration message.
Default: 2
■
Minimum: 1
■
Maximum: The lower of 10 or [(Max. Message Age / 2) -1]
■
Maximum Age – The maximum time (in seconds) a device can wait
◆
without receiving a configuration message before attempting to
reconverge. All device ports (except for designated ports) should
receive configuration messages at regular intervals. Any port that ages
out STA information (provided in the last configuration message)
becomes the designated port for the attached LAN. If it is a root port, a
new root port is selected from among the device ports attached to the
network. (References to "ports" in this section mean "interfaces," which
includes both ports and trunks.)
Default: 20
■
Minimum: The higher of 6 or [2 x (Hello Time + 1)]
■
Maximum: The lower of 40 or [2 x (Forward Delay - 1)]
■
– 209 –
| Spanning Tree Algorithm
C 8
HAPTER
Configuring Global Settings for STA