Flowcontrol - Edge-Core ECS3510-26P Management Manual

26-port fast ethernet layer 2 switch

Hide thumbs Also See for ECS3510-26P:

Table of Contents

The description is displayed by the

the running-configuration file. An example of the value which a network

manager might store in this object is the name of the manufacturer, and

the product name.

The following example adds a description to port 4.

Console(config)#interface ethernet 1/4

Console(config-if)#description RD-SW#3

Console(config-if)#

This command enables flow control. Use the no form to disable flow

flowcontrol

[no] flowcontrol

Interface Configuration (Ethernet, Port Channel)

1000BASE-T does not support forced mode. Auto-negotiation should

always be used to establish a connection over any 1000BASE-T port or

Flow control can eliminate frame loss by "blocking" traffic from end

stations or segments connected directly to the switch when its buffers

fill. When enabled, back pressure is used for half-duplex operation and

IEEE 802.3-2002 (formally IEEE 802.3x) for full-duplex operation.

To force flow control on or off (with the flowcontrol or no flowcontrol

command), use the no negotiation command to disable auto-

negotiation on the selected interface.

When using the

optimal settings will be determined by the

enable flow control under auto-negotiation, "flowcontrol" must be

included in the capabilities list for any port

| Interface Commands

Interface Configuration

show interfaces status

command to enable auto-negotiation, the

capabilities

command and in

Show Quick Links

Table of Contents