Remote Connections - Edge-Core ECS3510-26P Management Manual

■
■
■
Once you have set up the terminal correctly, the console login screen
N :
OTE
will be displayed.
For a description of how to use the CLI, see
Interface" on page
information on using the CLI, refer to
page 514.
Prior to accessing the switch's onboard agent via a network connection,
R
EMOTE
you must first configure it with a valid IP address, subnet mask, and
C
ONNECTIONS
default gateway using a console connection, or DHCP protocol.
An IPv4 address for this switch is obtained via DHCP by default. To
manually configure this address or enable dynamic address assignment via
DHCP, see
This switch supports four Telnet sessions or SSH sessions.
N :
OTE
After configuring the switch's IP parameters, you can access the onboard
configuration program from anywhere within the attached network. The
onboard configuration program can be accessed using Telnet from any
computer attached to the network. The switch can also be managed by any
computer using a web browser (Internet Explorer 6.x or above, or Mozilla
Firefox 4.x or above), or from a network computer using SNMP network
management software.
The onboard program only provides access to basic configuration functions.
To access the full range of SNMP management functions, you must use
SNMP-based network management software.
Set flow control to none.
Set the emulation mode to VT100.
When using HyperTerminal, select Terminal keys, not Windows
keys.
505. For a list of all the CLI commands and detailed
"Setting an IP Address" on page
– 63 –
| Initial Switch Configuration
C 2
HAPTER
Connecting to the Switch
"Using the Command Line
"CLI Command Groups" on
65.