Configuring A List Of Name Servers - Edge-Core ECS3510-26P Management Manual

| IP Services
C 16
HAPTER

Configuring a List of Name Servers

C L
ONFIGURING A IST OF
N S
AME ERVERS
Use the IP Service > DNS - General (Add Name Server) page to configure a
list of name servers to be tried in sequential order.
CLI R
EFERENCES
"ip name-server" on page 949
◆
◆ "show dns" on page 951
C U
OMMAND SAGE
◆ To enable DNS service on this switch, configure one or more name
servers, and enable domain lookup status (see
DNS Service Parameters" on page
When more than one name server is specified, the servers are queried
◆
in the specified sequence until a response is received, or the end of the
list is reached with no response.
If all name servers are deleted, DNS will automatically be disabled. This
◆
is done by disabling the domain lookup status.
P
ARAMETERS
These parameters are displayed:
Name Server IP Address – Specifies the IPv4 or IPv6 address of a
domain name server to use for name-to-address resolution. Up to six IP
addresses can be added to the name server list.
W I
EB NTERFACE
To create a list name servers:
Click IP Service, DNS, General.
1.
Select Add Name Server from the Action list.
2.
Enter one name server at a time.
3.
Click Apply.
4.
Figure 277: Configuring a List of Name Servers for DNS
– 466 –
"Configuring General
463).