Spanning-Tree Mst Configuration - Edge-Core ECS3510-26P Management Manual

| Spanning Tree Commands
C 32
HAPTER
spanning-tree
mst configuration
spanning-tree
transmission-limit
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Bridge priority is used in selecting the root device, root port, and
designated port. The device with the highest priority (i.e., lower numeric
value) becomes the STA root device. However, if all devices have the same
priority, the device with the lowest MAC address will then become the root
device.
E
XAMPLE
Console(config)#spanning-tree priority 40000
Console(config)#
This command changes to Multiple Spanning Tree (MST) configuration
mode.
D S
EFAULT ETTING
No VLANs are mapped to any MST instance.
The region name is set the switch's MAC address.
C M
OMMAND ODE
Global Configuration
E
XAMPLE
Console(config)#spanning-tree mst configuration
Console(config-mstp)#
R C
ELATED OMMANDS
mst vlan (804)
mst priority (804)
name (805)
revision (806)
max-hops (803)
This command configures the minimum interval between the transmission
of consecutive RSTP/MSTP BPDUs. Use the no form to restore the default.
S
YNTAX
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)
D S
EFAULT ETTING
3
– 802 –