Edge-Core ECS3510-26P Management Manual page 327

26-port fast ethernet layer 2 switch

Hide thumbs Also See for ECS3510-26P:

Table of Contents

Use the Security > ACL (Configure ACL - Add Rule - ARP) page to configure

ONFIGURING AN

ACLs based on ARP message addresses. ARP Inspection can then use these

ACLs to filter suspicious traffic (see

Inspection" on page

"permit, deny (ARP ACL)" on page 724

"show ip access-list" on page 718

"Time Range" on page 572

These parameters are displayed:

Type – Selects the type of ACLs to show in the Name list.

Name – Shows the names of ACLs matching the selected type.

Action – An ACL can contain any combination of permit or deny rules.

Packet Type – Indicates an ARP request, ARP response, or either type.

(Range: Request, Response, All; Default: All)

Source/Destination IP Address Type – Specifies the source or

destination IPv4 address. Use "Any" to include all possible addresses,

"Host" to specify a specific host address in the Address field, or "IP" to

specify a range of addresses with the Address and Mask fields.

(Options: Any, Host, IP; Default: Any)

Source/Destination IP Address – Source or destination IP address.

Source/Destination IP Subnet Mask – Subnet mask for source or

destination address. (See the description for Subnet Mask on

Source/Destination MAC Address Type – Use "Any" to include all

possible addresses, "Host" to indicate a specific MAC address, or "MAC"

to specify an address range with the Address and Mask fields.

(Options: Any, Host, MAC; Default: Any)

Source/Destination MAC Address – Source or destination MAC

Source/Destination MAC Bit Mask – Hexadecimal mask for source or

destination MAC address.

Log – Logs a packet when it matches the access control entry.

To add rules to an ARP ACL:

Click Security, ACL.

Select Configure ACL from the Step list.

| Security Measures

Access Control Lists

"Configuring Global Settings for ARP

Show Quick Links

Table of Contents