Interface Address Configuration And Utilities - Edge-Core ECS3510-26P Management Manual

Interface Address Configuration and Utilities

ipv6
default-gateway
Table 145: IPv6 Configuration Commands (Continued)
Command Function
Neighbor Discovery
clear ipv6 neighbors Deletes all dynamic entries in the IPv6 neighbor
discovery cache
show ipv6 neighbors Displays information in the IPv6 neighbor discovery
cache
This command sets an IPv6 default gateway to use when the destination is
located in a different network segment. Use the no form to remove a
previously configured default gateway.
S
YNTAX
ipv6 default-gateway ipv6-address
no ipv6 address
ipv6-address - The IPv6 address of the default next hop router to
use when the destination is located in a different network segment.
D S
EFAULT ETTING
No default gateway is defined
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
◆
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields.
The same link-local address may be used by different interfaces/nodes
◆
in different zones (RFC 4007). Therefore, when specifying a link-local
address, include zone-id information indicating the VLAN identifier after
the % delimiter. For example, FE80::7272%1 identifies VLAN 1 as the
interface from which the ping is sent.
An IPv6 default gateway must be defined if the destination has been
◆
assigned an IPv6 address and is located in a different IP segment.
An IPv6 default gateway can only be successfully set when a network
◆
interface that directly connects to the gateway has been configured on
the switch.
– 971 –
| IP Interface Commands
C 40
HAPTER
Interface Address Configuration and Utilities
Mode
PE
PE