Configuring Global Settings For Snmp - Edge-Core ECS3510-26P Management Manual

C G
ONFIGURING LOBAL
S SNMP
ETTINGS FOR
Use the Administration > SNMP (Configure Engine) page to change the
3.
local engine ID. If you want to change the default engine ID, it must be
changed before configuring other parameters.
Use the Administration > SNMP (Configure View) page to specify read
4.
and write access views for the switch MIB tree.
Use the Administration > SNMP (Configure User) page to configure
5.
SNMP user groups with the required security model (i.e., SNMP v1, v2c
or v3) and security level (i.e., authentication and privacy).
Use the Administration > SNMP (Configure Group) page to assign SNMP
6.
users to groups, along with their specific authentication and privacy
passwords.
Use the Administration > SNMP (Configure Global) page to enable SNMPv3
service for all management clients (i.e., versions 1, 2c, 3), and to enable
trap messages.
CLI R
EFERENCES
"snmp-server" on page 582
◆
"snmp-server enable traps" on page 585
◆
P
ARAMETERS
These parameters are displayed:
Agent Status – Enables SNMP on the switch. (Default: Enabled)
◆
Authentication Traps
◆
trap managers whenever an invalid community string is submitted
during the SNMP access authentication process. (Default: Enabled)
Link-up and Link-down Traps
◆
whenever a port link is established or broken. (Default: Enabled)
W I
EB NTERFACE
To configure global settings for SNMP:
Click Administration, SNMP.
1.
Select Configure Global from the Step list.
2.
Enable SNMP and the required trap types.
3.
Click Apply
4.
7. These are legacy notifications and therefore when used for SNMPv3 hosts, they must be
enabled in conjunction with the corresponding entries in the Notification View
– 399 –
| Basic Administration Protocols
C 14
HAPTER
Simple Network Management Protocol
– Issues a notification message to specified IP
7
7 – Issues a notification message
(page 402).