Mvr Type - Edge-Core ECS3510-26P Management Manual

26-port fast ethernet layer 2 switch

Hide thumbs Also See for ECS3510-26P:

Table of Contents

| Multicast Filtering Commands

Multicast VLAN Registration

mvr type

Interface Configuration (Ethernet, Port Channel)

Immediate leave applies only to receiver ports. When enabled, the

receiver port is immediately removed from the multicast group

identified in the leave message. When immediate leave is disabled, the

switch follows the standard rules by sending a group-specific query to

the receiver port and waiting for a response to determine if there are

any remaining subscribers for that multicast group before removing the

port from the group list.

Using immediate leave can speed up leave latency, but should only be

enabled on a port attached to only one multicast subscriber to avoid

disrupting services to other group members attached to the same

Immediate leave does not apply to multicast groups which have been

statically assigned to a port with the

The following enables immediate leave on a receiver port.

Console(config)#interface ethernet 1/5

Console(config-if)#mvr immediate

Console(config-if)#

This command configures an interface as an MVR receiver or source port.

Use the no form to restore the default settings.

[no] mvr type {receiver | source}

receiver - Configures the interface as a subscriber port that can

receive multicast data.

source - Configures the interface as an uplink port that can send

and receive multicast data for the configured multicast groups.

The port type is not defined.

Interface Configuration (Ethernet)

A port which is not configured as an MVR receiver or source port can

use IGMP snooping to join or leave multicast groups using the standard

rules for multicast filtering.

mvr vlan group

Show Quick Links

Table of Contents