Figure 29: Configuring Local Port Mirroring - Edge-Core ECS3510-26P Management Manual

MAC Address Mirroring" on page
the same target ports as that used for port mirroring by this command.
When traffic matches the rules for both port mirroring, and for
◆
mirroring of VLAN traffic or packets based on a MAC address, the
matching packets will not be sent to target port specified for port
mirroring.
Note that Spanning Tree BPDU packets are not mirrored to the target
◆
port.
The destination port cannot be a trunk or trunk member port.
◆
P
ARAMETERS
These parameters are displayed:
◆ Source Port – The port whose traffic will be monitored.
(Range: 1-26)
Target Port – The port that will mirror the traffic on the source port.
◆
(Range: 1-26)
Type – Allows you to select which traffic to mirror to the target port, Rx
◆
(receive), Tx (transmit), or Both. (Default: Both)
W I
EB NTERFACE
To configure a local mirror session:
Click Interface, Port, Mirror.
1.
Select Add from the Action List.
2.
Specify the source port.
3.
Specify the monitor port.
4.
Specify the traffic type to be mirrored.
5.
Click Apply.
6.

Figure 29: Configuring Local Port Mirroring

– 133 –
| Interface Configuration
C 5
HAPTER
Port Configuration
200), the target port cannot be set to