Permit, Deny - Edge-Core ECS3510-26P Management Manual

26-port fast ethernet layer 2 switch

Hide thumbs Also See for ECS3510-26P:

Table of Contents

This command sets the access mode for an IGMP filter profile. Use the no

permit, deny

form to delete a profile number.

{permit | deny}

IGMP Profile Configuration

Each profile has only one access mode; either permit or deny.

When the access mode is set to permit, IGMP join reports are

processed when a multicast group falls within the controlled range.

When the access mode is set to deny, IGMP join reports are only

processed when a multicast group is not in the controlled range.

Console(config)#ip igmp profile 19

Console(config-igmp-profile)#permit

Console(config-igmp-profile)#

This command specifies multicast group addresses for a profile. Use the no

form to delete addresses from a profile.

[no] range low-ip-address [high-ip-address]

IGMP Profile Configuration

Enter this command multiple times to specify more than one multicast

address or address range for a profile.

low-ip-address - A valid IP address of a multicast group or start of a

group range.

high-ip-address - A valid IP address for the end of a multicast group

| Multicast Filtering Commands

IGMP Filtering and Throttling

Show Quick Links

Table of Contents