Table 49: Event Logging Commands - Edge-Core ECS3510-26P Management Manual

E L
VENT OGGING
logging facility
This section describes commands used to configure event logging on the
switch.

Table 49: Event Logging Commands

Command Function
logging facility Sets the facility type for remote logging of syslog
messages
logging history Limits syslog messages saved to switch memory based
on severity
logging host Adds a syslog server host IP address that will receive
logging messages
logging on Controls logging of error messages
logging trap Limits syslog messages saved to a remote server
based on severity
clear log Clears messages from the logging buffer
show log Displays log messages
show logging Displays the state of logging
This command sets the facility type for remote logging of syslog messages.
Use the no form to return the type to the default.
S
YNTAX
logging facility type
no logging facility
type - A number that indicates the facility used by the syslog server
to dispatch log messages to an appropriate service. (Range: 16-23)
D S
EFAULT ETTING
23
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The command specifies the facility type tag sent in syslog messages. (See
RFC 3164.) This type has no effect on the kind of messages reported by
the switch. However, it may be used by the syslog server to sort messages
or to store messages in the corresponding database.
E
XAMPLE
Console(config)#logging facility 19
Console(config)#
– 555 –
| System Management Commands
C 20
HAPTER
Event Logging
Mode
GC
GC
GC
GC
GC
PE
PE
PE