Mapping Protocol Groups To Interfaces; Figure 73: Configuring Protocol Vlans - Edge-Core ECS3510-26P Management Manual

26-port fast ethernet layer 2 switch

Hide thumbs Also See for ECS3510-26P:

Table of Contents

To configure a protocol group:

Figure 74: Displaying Protocol VLANs

Use the VLAN > Protocol (Configure Interface - Add) page to map a

protocol group to a VLAN for each interface that will participate in the

Click Apply.

Click VLAN, Protocol.

Select Configure Protocol from the Step list.

Select Show from the Action list.

"protocol-vlan protocol-group (Configuring Interfaces)" on page 843

When creating a protocol-based VLAN, only assign interfaces using this

configuration screen. If you assign interfaces using any of the other

VLAN menus such as the VLAN Static table

will admit traffic of any protocol type into the associated VLAN.

When a frame enters a port that has been assigned to a protocol VLAN,

it is processed in the following manner:

If the frame is tagged, it will be processed according to the standard

rules applied to tagged frames.

| VLAN Configuration

Protocol VLANs

171), these interfaces

Show Quick Links

Table of Contents