Lldp Med-Fast-Start-Count - Edge-Core ECS3510-26P Management Manual

| LLDP Commands
C 37
HAPTER
lldp med-fast-start-
count
lldp
notification-interval
This command specifies the amount of MED Fast Start LLDPDUs to transmit
during the activation process of the LLDP-MED Fast Start mechanism.
S
YNTAX
lldp med-fast-start-count packets
seconds - Amount of packets. (Range: 1-10 packets;
Default: 4 packets)
D S
EFAULT ETTING
4 packets
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This parameter is part of the timer which ensures that the LLDP-MED Fast
Start mechanism is active for the port. LLDP-MED Fast Start is critical to
the timely startup of LLDP, and therefore integral to the rapid availability of
Emergency Call Service.
E
XAMPLE
Console(config)#lldp med-fast-start-count 6
Console(config)#
This command configures the allowed interval for sending SNMP
notifications about LLDP MIB changes. Use the no form to restore the
default setting.
S
YNTAX
lldp notification-interval seconds
no lldp notification-interval
seconds - Specifies the periodic interval at which SNMP notifications
are sent. (Range: 5 - 3600 seconds)
D S
EFAULT ETTING
5 seconds
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This parameter only applies to SNMP applications which use data stored
◆
in the LLDP MIB for network monitoring or management.
Information about changes in LLDP neighbors that occur between SNMP
◆
notifications is not transmitted. Only state changes that exist at the
time of a notification are included in the transmission. An SNMP agent
– 924 –