Edge-Core ECS3510-26P Management Manual page 883

E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the set ip dscp command to
classify the service that incoming packets will receive, and then uses the
police flow command to limit the average bandwidth to 100,000 Kbps, the
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police flow 10000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
This command services IP traffic by setting a per-hop behavior value for a
set phb
matching packet (as specified by the
processing. Use the no form to remove this setting.
S
YNTAX
[no] set phb phb-value
phb-value - Per-hop behavior value. (Range: 0-7)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Policy Map Class Configuration
C U
OMMAND SAGE
The set phb command is used to set an internal QoS value in hardware
◆
for matching packets (see
to Internal PHB/Drop
three bits for per-hop behavior, and two bits for the color scheme used
to control queue congestion by the
police trtcm-color
◆ The set cos
priority. Therefore setting either of these commands will overwrite any
action already configured by the other command.
C
HAPTER
match
Table 123, "Default Mapping of DSCP Values
Values"). The QoS label is composed of five bits,
command.
and set phb command function at the same level of
– 883 –
| Quality of Service Commands
35
class command to
command) for internal
police srtcm-color command and