Edge-Core ECS3510-26P Management Manual page 301

Network Access Max MAC Count
◆
MAC addresses that can be authenticated on a port interface via all
forms of authentication (including Network Access and IEEE 802.1X).
(Range: 1-1024; Default: 1024)
Guest VLAN – Specifies the VLAN to be assigned to the port when
◆
802.1X Authentication fails. (Range: 0-4093, where 0 means disabled;
Default: Disabled)
The VLAN must already be created and active (see
Groups" on page 170). Also, when used with 802.1X authentication,
intrusion action must be set for "Guest VLAN" (see
Authenticator Settings for 802.1X" on page
Dynamic VLAN – Enables dynamic VLAN assignment for an
◆
authenticated port. When enabled, any VLAN identifiers returned by the
RADIUS server through the 802.1X authentication process are applied
to the port, providing the VLANs have already been created on the
switch. (GVRP is not used to create the VLANs.) (Default: Enabled)
The VLAN settings specified by the first authenticated MAC address are
implemented for a port. Other authenticated MAC addresses on the
port must have the same VLAN configuration, or they are treated as
authentication failures.
If dynamic VLAN assignment is enabled on a port and the RADIUS
server returns no VLAN configuration (to the 802.1X authentication
process), the authentication is still treated as a success, and the host is
assigned to the default untagged VLAN.
When the dynamic VLAN assignment status is changed on a port, all
authenticated addresses mapped to that port are cleared from the
secure MAC address table.
◆ Dynamic QoS – Enables dynamic QoS assignment for an
authenticated port. (Default: Disabled)
◆ MAC Filter ID – Allows a MAC Filter to be assigned to the port. MAC
addresses or MAC address ranges present in a selected MAC Filter are
exempt from authentication on the specified port (as described under
"Configuring a MAC Address
W I
EB NTERFACE
To configure MAC authentication on switch ports:
Click Security, Network Access.
1.
Select Configure Interface from the Step list.
2.
Click the General button.
3.
Make any configuration changes required to enable address
4.
authentication on a port, set the maximum number of secure addresses
supported, the guest VLAN to use when MAC Authentication or 802.1X
Authentication fails, and the dynamic VLAN and QoS assignments.
– 301 –
C 13
HAPTER
Network Access (MAC Address Authentication)
– Sets the maximum number of
5
"Configuring VLAN
"Configuring Port
345).
Filter"). (Range: 1-64; Default: None)
| Security Measures