D
ISPLAYING
C
S
ONNECTION
TATUS
Figure 30: Configuring Connections by Port Range
Use the Interface > Port > General (Show Information) page to display the
current connection status, including link state, speed/duplex mode, flow
control, and auto-negotiation.
CLI R
EFERENCES
"show interfaces status" on page 987
◆
P
ARAMETERS
These parameters are displayed:
Port – Port identifier.
◆
Type – Indicates the port type. (100BASE-TX, 1000BASE-T,
◆
100BASE SFP or 1000BASE SFP)
Name – Interface label.
◆
Admin – Shows if the port is enabled or disabled.
◆
Oper Status – Indicates if the link is Up or Down.
◆
◆
Media Type – Media type used.
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
◆
Oper Speed Duplex – Shows the current speed and duplex mode.
◆
Oper Flow Control – Shows the flow control type used.
◆
W
I
EB
NTERFACE
To display port connection parameters:
Click Interface, Port, General.
1.
Select Show Information from the Action List.
2.
– 153 –
| Interface Configuration
C
5
HAPTER
Port Configuration