Description - Edge-Core ECS3510-26P Management Manual

| Interface Commands
C 26
HAPTER
Interface Configuration

description

D S
EFAULT ETTING
100BASE-FX: 100full (SFP)
100BASE-TX: 10half, 10full, 100half, 100full
1000BASE-T: 10half, 10full, 100half, 100full, 1000full
1000BASE-SX/LX/LH (SFP): 1000full
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
The 1000BASE-T standard does not support forced mode. Auto-
◆
negotiation should always be used to establish a connection over any
1000BASE-T port or trunk.
When auto-negotiation is enabled with the
◆
switch will negotiate the best settings for a link based on the
capabilities command. When auto-negotiation is disabled, you must
manually specify the link attributes with the
flowcontrol commands.
E
XAMPLE
The following example configures Ethernet port 5 capabilities to include
100half and 100full.
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#
R C
ELATED OMMANDS
negotiation (735)
speed-duplex (736)
flowcontrol (733)
This command adds a description to an interface. Use the no form to
remove the description.
S
YNTAX
description string
no description
string - Comment or a description to help you remember what is
attached to this interface. (Range: 1-64 characters)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
– 732 –
negotiation command, the
speed-duplex and