Configuring Interface Settings For Web Authentication - Edge-Core ECS3510-26P Management Manual

| Security Measures
C 13
HAPTER
Network Access (MAC Address Authentication)
N A
ETWORK CCESS
W I
EB NTERFACE
To enable web authentication for a port:
Click Security, Web Authentication.
1.
Select Configure Interface from the Step list.
2.
Set the status box to enabled for any port that requires web
3.
authentication, and click Apply
Mark the check box for any host addresses that need to be re-
4.
authenticated, and click Re-authenticate.
Figure 157: Configuring Interface Settings for Web Authentication
(MAC A A
DDRESS UTHENTICATION
Some devices connected to switch ports may not be able to support 802.1X
authentication due to hardware or software limitations. This is often true
for devices such as network printers, IP phones, and some wireless access
points. The switch enables network access from these devices to be
controlled by authenticating device MAC addresses with a central RADIUS
server.
RADIUS authentication must be activated and configured properly
N :
OTE
for the MAC Address authentication feature to work properly. (See
"Configuring Remote Logon Authentication Servers" on page
MAC authentication cannot be configured on trunk ports.
N :
OTE
CLI R
EFERENCES
"Network Access (MAC Address Authentication)" on page 666
◆
C U
OMMAND SAGE
MAC address authentication controls access to the network by
◆
authenticating the MAC address of each host that attempts to connect
)
– 296 –
278.)