Edge-Core ECS3510-26P Management Manual page 478

| Multicast Filtering
C 17
HAPTER
Layer 2 IGMP (Snooping and Query)
CLI R
EFERENCES
◆ "Static Multicast Routing" on page 906
C U
OMMAND SAGE
IGMP Snooping must be enabled globally on the switch (see
IGMP Snooping and Query Parameters" on page
router port can take effect.
P
ARAMETERS
These parameters are displayed:
Add Static Multicast Router
VLAN – Selects the VLAN which is to propagate all multicast traffic
◆
coming from the attached multicast router. (Range: 1-4093)
Interface – Activates the Port or Trunk scroll down list.
◆
Port or Trunk – Specifies the interface attached to a multicast router.
◆
Show Static Multicast Router
VLAN – Selects the VLAN for which to display any configured static
◆
multicast routers.
Interface – Shows the interface to which the specified static multicast
◆
routers are attached.
Show Current Multicast Router
VLAN – Selects the VLAN for which to display any currently active
◆
multicast routers.
Interface – Shows the interface to which an active multicast router is
◆
attached.
Type – Shows if this entry is static or dynamic.
◆
W I
EB NTERFACE
To specify a static interface attached to a multicast router:
Click Multicast, IGMP Snooping, Multicast Router.
1.
Select Add Static Multicast Router from the Action list.
2.
Select the VLAN which will forward all the corresponding multicast
3.
traffic, and select the port or trunk attached to the multicast router.
Click Apply.
4.
– 478 –
"Configuring
474) before a multicast