Resetting The System - Edge-Core ECS3510-26P Management Manual

| Basic Management Tasks
C 4
HAPTER

Resetting the System

R S
ESETTING THE YSTEM
W I
EB NTERFACE
To display memory utilization:
Click System, then Memory Status.
1.
Figure 20: Displaying Memory Utilization
Use the System > Reload menu to restart the switch immediately, at a
specified time, after a specified delay, or at a periodic interval.
CLI R
EFERENCES
"reload (Privileged Exec)" on page 522
◆
"reload (Global Configuration)" on page 518
◆
◆ "show reload" on page 523
"copy running-config startup-config" on page 536
◆
C U
OMMAND SAGE
◆ This command resets the entire system.
To retain all configuration information stored in non-volatile memory,
◆
click the Save button prior to resetting the system.
When the system is restarted, it will always run the Power-On Self-Test.
◆
It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config
"copy" on page 536).
P
ARAMETERS
The following parameters are displayed:
System Reload Information
Reload Settings – Displays information on the next scheduled reload
◆
and selected reload mode as shown in the following example:
"The switch will be rebooted at March 9 12:00:00 2012. Remaining
Time: 0 days, 2 hours, 46 minutes, 5 seconds.
Reloading switch regularly time: 12:00 everyday."
– 122 –
command (See