Threshold Commands - Edge-Core ECS3510-26P Management Manual

| Automatic Traffic Control Commands
C 30
HAPTER

Threshold Commands

Threshold Commands
auto-traffic-control
apply-timer
auto-traffic-control
release-timer
This command sets the time at which to apply the control response after
ingress traffic has exceeded the upper threshold. Use the no form to
restore the default setting.
S
YNTAX
auto-traffic-control {broadcast | multicast} apply-timer seconds
no auto-traffic-control {broadcast | multicast} apply-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
seconds - The interval after the upper threshold has been exceeded
at which to apply the control response. (Range: 1-300 seconds)
D S
EFAULT ETTING
300 seconds
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
After the apply timer expires, a control action may be triggered as specified
by the auto-traffic-control action
specified by the snmp-server enable port-traps atc broadcast-control-apply
command or snmp-server enable port-traps atc multicast-control-apply
command.
E
XAMPLE
This example sets the apply timer to 200 seconds for all ports.
Console(config)#auto-traffic-control broadcast apply-timer 200
Console(config)#
This command sets the time at which to release the control response after
ingress traffic has fallen beneath the lower threshold. Use the no form to
restore the default setting.
S
YNTAX
auto-traffic-control {broadcast | multicast}
release-timer seconds
no auto-traffic-control {broadcast | multicast} release-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
– 776 –
command and a trap message sent as