Chapter 4
| Interface Configuration
Port Configuration
Displaying
Connection Status
5.
Click Apply.
Figure 30: Configuring Connections by Port Range
Use the Interface > Port > General (Show Information) page to display the current
connection status, including link state, speed/duplex mode, flow control, and auto-
negotiation.
Parameters
These parameters are displayed:
◆
Port – Port identifier.
◆
Type – Indicates the port type. (1000Base-T, 100Base SFP or 1000Base SFP)
◆
Name – Interface label.
◆
Admin – Shows if the port is enabled or disabled.
◆
Oper Status – Indicates if the link is Up or Down.
◆
Media Type – Not applicable for this switch.
◆
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
◆
Oper Speed Duplex – Shows the current speed and duplex mode.
◆
Oper Flow Control – Shows the flow control type used.
– 98 –