Management Ip Filter; Management; Table 76: Management Ip Filter Commands - Edge-Core ECS3510-26P Management Manual

| Authentication Commands
C 23
HAPTER

Management IP Filter

M IP F
ANAGEMENT ILTER

management

Identifier(Server) : 2
Reauthentication State Machine
State : Initialize
Console#
This section describes commands used to configure IP management access
to the switch.

Table 76: Management IP Filter Commands

Command Function
management Configures IP addresses that are allowed management
access
show management Displays the switch to be monitored or configured from
a browser
This command specifies the client IP addresses that are allowed
management access to the switch through various protocols. Use the no
form to restore the default setting.
S
YNTAX
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
all-client - Adds IP address(es) to all groups.
http-client - Adds IP address(es) to the web group.
snmp-client - Adds IP address(es) to the SNMP group.
telnet-client - Adds IP address(es) to the Telnet group.
start-address - A single IP address, or the starting address of a
range.
end-address - The end address of a range.
D S
EFAULT ETTING
All addresses
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
If anyone tries to access a management interface on the switch from an
◆
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
– 660 –
Mode
GC
PE