Dot1X Timeout Start-Period; Display Information Commands; Show Dot1X - Edge-Core ECS3510-26P Management Manual

dot1x timeout
start-period

Display Information Commands

show dot1x

This command sets the time that a supplicant port waits before resending
an EAPOL start frame to the authenticator. Use the no form to restore the
default setting.
S
YNTAX
dot1x timeout start-period seconds
no dot1x timeout start-period
seconds - The number of seconds. (Range: 1-65535)
D
EFAULT
30 seconds
C M
OMMAND ODE
Interface Configuration
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout start-period 60
Console(config-if)#
This command shows general port authentication related settings on the
switch or a specific interface.
S
YNTAX
show dot1x [statistics] [interface interface]
statistics - Displays dot1x status for each port.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-26)
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
This command displays the following information:
Global 802.1X Parameters – Shows whether or not 802.1X port
◆
authentication is globally enabled on the switch
◆ Authenticator Parameters – Shows whether or not EAPOL pass-through
is enabled (page 646).
– 657 –
| Authentication Commands
C 23
HAPTER
802.1X Port Authentication
(page 647).