Service-Policy - Edge-Core ECS3510-26P Management Manual

| Quality of Service Commands
C 35
HAPTER

service-policy

E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the set phb command to
classify the service that incoming packets will receive, and then uses the
police flow command to limit the average bandwidth to 100,000 Kbps, the
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set phb 3
Console(config-pmap-c)#police flow 10000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
This command applies a policy map defined by the policy-map command
to the ingress side of a particular interface. Use the no form to remove this
mapping.
S
YNTAX
[no] service-policy input policy-map-name
input - Apply to the input traffic.
policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
D S
EFAULT ETTING
No policy map is attached to an interface.
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
Only one policy map can be assigned to an interface.
◆
First define a class map, then define a policy map, and finally use the
◆
service-policy command to bind the policy map to the required
interface.
◆ The switch does not allow a policy map to be bound to an interface for
egress traffic.
E
XAMPLE
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd-policy
Console(config-if)#
– 884 –
class command to