Stopbits - Edge-Core ECS3510-26P Management Manual

D S
EFAULT ETTING
auto
C M
OMMAND ODE
Line Configuration
C U
OMMAND SAGE
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might not
be supported. The system indicates if the speed you selected is not
supported. If you select the "auto" option, the switch will automatically
detect the baud rate configured on the attached terminal, and adjust the
speed accordingly.
Due to a hardware limitation, the terminal program connected to the
N :
OTE
console port must be set to 8 data bits when using auto baud rate
detection.
E
XAMPLE
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#
This command sets the number of the stop bits transmitted per byte. Use

stopbits

the no form to restore the default setting.
S
YNTAX
stopbits {1 | 2}
no stopbits
1 - One stop bit
2 - Two stop bits
D S
EFAULT ETTING
1 stop bit
C M
OMMAND ODE
Line Configuration
E
XAMPLE
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
| System Management Commands
C 20
HAPTER
– 551 –
Line