Table 139: Dhcp Commands; Table 140: Dhcp Client Commands - Edge-Core ECS3510-26P Management Manual

39
DHCP C
LIENT
DHCP for IPv4
ip dhcp client
class-id
DHCP C
OMMANDS
These commands are used to configure Dynamic Host Configuration
Protocol (DHCP) client functions.

Table 139: DHCP Commands

Command Group Function
DHCP Client Allows interfaces to dynamically acquire IP address information
Use the commands in this section to allow the switch's VLAN interfaces to
dynamically acquire IP address information.

Table 140: DHCP Client Commands

Command
DHCP for IPv4
ip dhcp client class-id
ip dhcp restart client
DHCP for IPv6
ipv6 dhcp client rapid-commit
vlan
ipv6 dhcp restart client vlan
show ip dhcp client-identifier
show ipv6 dhcp duid
show ipv6 dhcp vlan
This command specifies the DCHP client vendor class identifier for the
current interface. Use the no form to remove the class identifier from the
DHCP packet.
S
YNTAX
ip dhcp client class-id [text text | hex hex]
no ip dhcp client class-id
text - A text string. (Range: 1-32 characters)
– 955 –
Function
Specifies the DHCP client identifier for an interface
Submits a BOOTP or DHCP client request
Specifies the Rapid Commit option for DHCPv6
message exchange
Submits a DHCPv6 client request
Shows the DHCP client identifier for all interfaces
Shows the DHCP Unique Identifier for this switch
Shows DHCPv6 information for specified interface
Mode
IC
PE
GC
PE
PE
PE
PE