Figure 128: Configuring A Policy Map - Edge-Core ECS3510-26P Management Manual

| Quality of Service
C 11
HAPTER
Creating QoS Policies
Conform – Specifies that traffic conforming to the maximum
■
rate (CIR) will be transmitted without any change to the DSCP
service level.
Transmit – Transmits in-conformance traffic without any
■
change to the DSCP service level.
Exceed – Specifies whether traffic that exceeds the maximum
■
rate (CIR) but is within the peak information rate (PIR) will be
dropped or the DSCP service level will be reduced.
Set IP DSCP – Decreases DSCP priority for out of
■
conformance traffic. (Range: 0-63).
Drop – Drops out of conformance traffic.
■
Violate – Specifies whether the traffic that exceeds the peak
■
information rate (PIR) will be dropped or the DSCP service level
will be reduced.
Set IP DSCP – Decreases DSCP priority for out of
■
conformance traffic. (Range: 0-63).
Drop – Drops out of conformance traffic.
■
W I
EB NTERFACE
To configure a policy map:
Click Traffic, DiffServ.
1.
Select Configure Policy from the Step list.
2.
Select Add from the Action list.
3.
Enter a policy name.
4.
Enter a description.
5.
Click Add.
6.

Figure 128: Configuring a Policy Map

– 264 –