Show Sntp; Sntp Server - Edge-Core ECS3510-26P Management Manual

R
ELATED
sntp client (565)
This command sets the IP address of the servers to which SNTP time

sntp server

requests are issued. Use the this command with no arguments to clear all
time servers from the current list. Use the no form to clear all time servers
from the current list, or to clear a specific server.
S
YNTAX
sntp server [ip1 [ip2 [ip3]]]
no sntp server [ip1 [ip2 [ip3]]]
ip - IP address of an time server (NTP or SNTP).
(Range: 1 - 3 addresses)
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
This command specifies time servers from which the switch will poll for
time updates when set to SNTP client mode. The client will poll the time
servers in the order specified until a response is received. It issues time
synchronization requests based on the interval set via the
command.
E
XAMPLE
Console(config)#sntp server 10.1.0.19
Console#
R
ELATED
sntp client (565)
sntp poll (566)

show sntp (567)

This command displays the current time and configuration settings for the
show sntp
SNTP client, and indicates whether or not the local time has been properly
updated.
C
OMMAND
Normal Exec, Privileged Exec
C
OMMAND
This command displays the current time, the poll interval used for sending
time synchronization requests, and the current SNTP mode (i.e., unicast).
C
C
OMMANDS
S
ETTING
M
ODE
U
SAGE
C
OMMANDS
M
ODE
U
SAGE
– 567 –
| System Management Commands
20
HAPTER
Time
sntp poll