Assigning Static Mvr Multicast Groups To Interfaces - Edge-Core ECS3510-26P Management Manual

| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration
A S
SSIGNING TATIC
MVR M
ULTICAST
G
ROUPS TO
I
NTERFACES
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.
Immediate Leave – Configures the switch to immediately remove an
◆
interface from a multicast stream as soon as it receives a leave
message for that group. (This option only applies to an interface
configured as an MVR receiver.)
W I
EB NTERFACE
To configure interface settings for MVR:
Click Multicast, MVR.
1.
Select Configure Interface from the Step list.
2.
Set each port that will participate in the MVR protocol as a source port
3.
or receiver port, and optionally enable Immediate Leave on any
receiver port to which only one subscriber is attached.
Click Apply.
4.
Figure 301: Configuring Interface Settings for MVR
Use the Multicast > MVR (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI R
EFERENCES
"mvr vlan group" on page 917
◆
C U
OMMAND SAGE
Multicast groups can be statically assigned to a receiver port using this
◆
configuration page.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for
◆
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
– 498 –