Negotiation - Edge-Core ECS3510-26P Management Manual

E
XAMPLE
This forces the switch port to master mode on port 24.
Console(config)#interface ethernet 1/50
Console(config-if)#no negotiation
Console(config-if)#speed-duplex 1000full
Console(config-if)#giga-phy-mode master
Console(config-if)#
This command enables auto-negotiation for a given interface. Use the no

negotiation

form to disable auto-negotiation.
S
YNTAX
[no] negotiation
D
EFAULT
Enabled
C
OMMAND
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
1000BASE-T does not support forced mode. Auto-negotiation should
◆
always be used to establish a connection over any 1000BASE-T port or
trunk.
◆ When auto-negotiation is enabled the switch will negotiate the best
settings for a link based on the
negotiation is disabled, you must manually specify the link attributes
with the
If auto-negotiation is disabled, auto-MDI/MDI-X pin signal configuration
◆
will also be disabled for the RJ-45 ports.
E
XAMPLE
The following example configures port 11 to use auto-negotiation.
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#
R
ELATED
capabilities (731)
speed-duplex (736)
S
ETTING
M
ODE
U
SAGE
speed-duplex and flowcontrol
C
OMMANDS
– 735 –
| Interface Commands
C 26
HAPTER
Interface Configuration
capabilities command. When auto-
commands.