Switchport Voice Vlan - Edge-Core ECS3510-26P Management Manual

This command specifies the Voice VLAN mode for ports. Use the no form to
switchport voice
disable the Voice VLAN feature on the port.
vlan
S
YNTAX
D
EFAULT
Disabled
C
OMMAND
Interface Configuration
C
OMMAND
◆
◆
E
XAMPLE
The following example sets port 1 to Voice VLAN auto mode.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan auto
Console(config-if)#
This command specifies a CoS priority for VoIP traffic on a port. Use the no
switchport voice
form to restore the default priority on a port.
vlan priority
S
YNTAX
D
EFAULT
6
switchport voice vlan {manual | auto}
no switchport voice vlan
manual - The Voice VLAN feature is enabled on the port, but the
port must be manually added to the Voice VLAN.
auto - The port will be added as a tagged member to the Voice
VLAN when VoIP traffic is detected on the port.
S
ETTING
M
ODE
U
SAGE
When auto is selected, you must select the method to use for detecting
VoIP traffic, either OUI or 802.1ab (LLDP) using the
vlan rule command. When OUI is selected, be sure to configure the
MAC address ranges in the Telephony OUI list using the
address command.
All ports are set to VLAN access mode by default. Prior to enabling VoIP
for a port (by setting the VoIP mode to Auto or Manual as described
below), ensure that VLAN membership is not set to access mode using
the switchport mode command.
switchport voice vlan priority priority-value
no switchport voice vlan priority
priority-value - The CoS priority value. (Range: 0-6)
S
ETTING
– 853 –
| VLAN Commands
C 33
HAPTER
Configuring Voice VLANs
switchport voice
voice vlan mac-