Specifying Sntp Time Servers; Figure 13: Setting The Polling Interval For Sntp - Edge-Core ECS3510-26P Management Manual

3.
4.
5.

Figure 13: Setting the Polling Interval for SNTP

Use the System > Time (Configure Time Server) page to specify the IP
S SNTP
PECIFYING
address for up to three SNTP time servers.
T S
IME ERVERS
CLI R
◆
P
ARAMETERS
The following parameters are displayed:
◆
W
EB
To set the SNTP time servers:
1.
2.
3.
4.
Select SNTP from the Maintain Type list.
Modify the polling interval if required.
Click Apply
EFERENCES
"sntp server" on page 567
SNTP Server IP Address – Sets the IPv4 or IPv6 address for up to
three time servers. The switch attempts to update the time from the
first server, if this fails it attempts an update from the next server in the
sequence.
I
NTERFACE
Click System, then Time.
Select Configure Time Server from the Step list.
Enter the IP address of up to three time servers.
Click Apply.
– 113 –
| Basic Management Tasks
C 4
HAPTER
Setting the System Clock