Opr Basic Parameters - Mitsubishi Electric QD75MH1 User Manual

5 DATA USED FOR POSITIONING CONTROL

5.2.5 OPR basic parameters

Item
Pr.43
OPR method
OPR method
0 : Near-point dog method
(1) Start machine OPR.
(Start movement at the "
Pr.44
" OPR direction".)
(2) Detect the near-point dog ON, and start deceleration.
(3) Decelerate to "
creep speed.
(At this time, the near-point dog must be ON. If the near-
point dog is OFF, the axis will decelerate to a stop.)
(4) At the first zero signal after the near-point dog turned OFF,
machine OPR is completed.
Note) After the home position return (OPR) has been
started, the zero point of the encoder must be passed
at least once before point A is reached.
However, if selecting "1: It is not necessary to pass
through the Z phase after the power on." with "
Pr.180 Function selection C-4", it is possible to
carried out the home position return (OPR).
Setting value, setting range
Value set with peripheral device
0 : Near-point dog method
4 : Count method 1)
5 : Count method 2)
6 : Data set method
Pr.43 OPR method
Set the "OPR method" for carrying out machine OPR.
0 : Near-point dog method ........ After decelerating at the near-point dog ON, stop
4 : Count method 1) .................. After decelerating at the near-point dog ON, move
5 : Count method 2) .................. After decelerating at the near-point dog ON, move
6 : Data set method................... The position where the machine OPR has been
Note) Refer to Section 8.2.2 "Machine OPR method" for details on the OPR
methods.
Pr.46 OPR speed" in the
Pr.47
Creep speed", and move with the
Value set with PLC program
0
4
5
6
at the zero signal and complete the machine
OPR.
the designated distance, and complete the
machine OPR with the zero signal.
the designated distance, and complete the
machine OPR.
made will be the OP.
V
(1)
Near-point dog OFF
Zero signal
5 - 50
MELSEC-Q
Setting value buffer memory
Default
address
value
Axis 1 Axis 2 Axis 3 Axis 4
0 70 220
OPR speed
Pr.46
(2)
Pr.47
Creep speed
(3) (4)
A
ON
370 520
t