Component List - Mitsubishi Electric QD75MH1 User Manual

2 SYSTEM CONFIGURATION

2.2 Component list

No. Part name
1 Positioning module
GX Configurator-
2
QP
3 Personal computer
4 RS-232 cable
5 USB cable
6 Servo amplifier
Manual pulse
7
generator
SSCNET cable
1
(For connecting
8
between the
QD75MH and the
servo amplifier)
Cable 1
(For connecting
9 between the
QD75MH and the
external device)
1: The SSCNET cable connecting the QD75MH and servo amplifier, external device connection connector has been
prepared. Refer to the below table.
The positioning system using the QD75MH is configured of the following devices.
Type
QD75MH
QD75MH1
QD75MH2
QD75MH4
SW D5C-QD75P-
Refer to GX Configurator-QP Operating Manual for details.
E
(Prepared by user)
DOS/V personal
computer
Refer to GX Configurator-QP Operating Manual for details.
(Prepared by user)
An RS-232 cable is needed for connecting the CPU module with a
QC30R2
personal computer (DOS/V).
For details, refer to GX Configurator-QP Operating Manual.
(Prepared by user)
A USB cable is needed for connecting the CPU module with a personal
–
computer (DOS/V).
For details, refer to GX Configurator-QP Operating Manual.
– (Prepared by user)
(Prepared by user)
–
Recommended: MR-HDP01 (Mitsubishi Electric)
(Prepared by user)
–
Cables are needed to connect the QD75MH with the servo amplifier.
(Prepared by user)
Cables are needed to connect the QD75MH with the external device.
–
(Prepare them referring to the manuals for the connected devices and
information given in 3.4.2 of this manual.)
Remarks
Number of control axes
MH: SSCNET model
2 - 4
MELSEC-Q