Mitsubishi Electric QD75MH1 User Manual page 587

12 CONTROL SUB FUNCTIONS
[Conditions]
Assume the current stop position is 2000, and the upper stroke limit is set to 5000.
[Current value changing]
When the current value is changed by a new current value command from 2000 to 1000, the
current value will change to 1000, but the machine feed value will stay the same at 2000.
1) When the machine feed value is set at the limit
The machine feed value of 5000 (current feed value: 4000) becomes the upper stroke limit.
2) When the current feed value is set at the limit
The current feed value of 5000 (machine feed value: 6000) becomes the upper stroke limit.
Fig. 12.15 Software stroke limits of the current feed value and machine feed value
The following drawing shows the differences in the operation when "
Current feed value" and "
range limit check.
Md. 20 Current feed value
Md. 21 Machine feed value
Md. 20 Current feed value
Md. 21 Machine feed value
Md. 20 Current feed value
Md. 21 Machine feed value
POINT
When "machine feed value" is set in "
moveable range becomes an absolute range referenced on the OP. When "current
feed value" is set, the moveable range is the relative range from the "current feed
value".
Md.21 Machine feed value" are used in the moveable
Moveable range
2000
2000
Stop position
Moveable range
1000
2000
Upper stroke limit
Moveable range
1000
2000
Pr.14
Software stroke limit selection", the
12 - 30
MELSEC-Q
5000
5000
Upper stroke limit
4000 5000
5000 6000
4000 5000
5000 6000
Upper stroke limit
Md.20