Mitsubishi Electric QD75MH1 User Manual page 186

5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Servo amplifier setting invalid
( : Valid, : Invalid)
MR-J3-B
2: The PD corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.
Value set with PLC program
0 0
H
Output signal device
selection 2
1: is used to set up the setting
value. (Hexadecimal)
0 0
H
Output signal device
selection 3
1: is used to set up the setting
value. (Hexadecimal)
5 - 89
MELSEC-Q
Setting value buffer memory
address
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
0004
30203 30403 30603 30803
H
0003 30204 30404 30604 30804
H