Mitsubishi Electric QD75MH1 User Manual page 168

5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Servo amplifier setting invalid
( : Valid, : Invalid)
MR-J3-B
2: The PB corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.
Value set with PLC program
0 to 100
0 to 3000
1 to 2000
1 to 1000
20 to 50000
5 - 71
MELSEC-Q
Setting value buffer memory
address
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
0 30122 30322 30522 30722
70 30124 30324 30524 30724
24 30125 30325 30525 30725
37 30126 30326 30526 30726
823 30127 30327 30527 30727