Mitsubishi Electric QD75MH1 User Manual page 176

5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Servo amplifier setting invalid
( : Valid, : Invalid)
MR-J3-B
2: The PB corresponds with servo parameter No. of the servo amplifier.
3: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75MH), then switch it
on again to make that parameter setting valid.
Value set with PLC program
0 to 3000
1 to 2000
20 to 50000
1 to 50000
1 to 1000
1 to 1000
5 - 79
MELSEC-Q
Setting value buffer memory
address
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
70 30147 30347 30547 30747
37 30148 30348 30548 30748
823 30149 30349 30549 30749
337 30150 30350 30550 30750
1000 30151 30351 30551 30751
1000 30152 30352 30552 30752