Mitsubishi Electric QD75MH1 User Manual page 351

Type qd75mh positioning module
Table of Contents

Advertisement

7 MEMORY CONFIGURATION AND DATA PROCESS
(3) Validate parameters when PLC READY signal [Y0] changes from
OFF to ON
When the PLC READY signal [Y0] changes from OFF to ON, the data stored in
the buffer memory's "parameter area (a)
2: Parameter area (a) ..... Parameters validated when PLC READY signal [Y0]
POINT
The setting values of the parameters that correspond to parameter area (b) are
valid when written into the buffer memory with the TO command.
However, the setting values of the parameters that correspond to parameter area
(a) are not validated until the PLC READY signal [Y0] changes from OFF to ON.
(4) Accessing with FROM command from PLC CPU (
The data is read from the buffer memory to the PLC CPU using the FROM
command.
(5) Reading the servo parameter from the servo amplifier (
When the parameter of the servo amplifier side is changed, the servo parameter
is read automatically from the servo amplifier to the buffer memory.
2" is validated.
changes from OFF to ON.
Pr.1
Pr.7
(
to
,
Pr.57
to
,
Pr.80
7 - 10
MELSEC-Q
Pr.11
Pr.24
Pr.43
to
,
to
)
Pr.83
)
)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Qd75mh2Qd75mh4

Table of Contents