Logging Sendmail Destination-Email - Edge-Core ECS4120-28F Reference Manual

Example
This example will send email alerts for system errors from level 3 through 0.
logging sendmail
This command specifies the email recipients of alert messages. Use the no form to
destination-email remove a recipient.
Syntax
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must enter a
separate command to specify each recipient.
Example
logging sendmail
This command sets the email address used for the "From" field in alert messages.
source-email Use the no form to restore the default value.
Syntax
Default Setting
None
Command Mode
Global Configuration
Console(config)#logging sendmail level 3
Console(config)#
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Console(config)#logging sendmail destination-email ted@this-company.com
Console(config)#
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
– 153 –
Chapter 4
| System Management Commands
SMTP Alerts